Join Date: Jul 2011
Location: Lexington, Missouri
I've been reading older post about your problem and there seems to be several causes. One person said they took the cluster apart and found corrosion on the circuit board, they cleaned it with a brush and it started working. Others found a broken wire along the harness. The only way I've read to reset is pretty much what you did by disconnecting the power, one person did say they touched the cables together after they disconnected them to drain any stored power in the system.
If you haven't done it already you might try some dielectric grease on the connections.
'07 Prowler 650 H1 XT, L.E.D. stop/turn signals, Summit Racing heater, AC winch, AC windshield, soft cab & doors, 6' Eagle Plow, oil gauge, Maxxis MT-762 truck tires, AC Fender Flares, E-Brake alarm, Yutrax UTV Jump Seat, Dynatek CDI
Last edited by mlh1962; 07-18-2017 at 07:31 AM.