2007 PROWLER several issues HELP !! - Arctic Cat Prowler Forums: Prowler UTV Forum
Arctic Cat Prowler General Discussions General discussions pertaining to the Arctic Cat Prowler.

 
LinkBack Thread Tools
Old 04-26-2013, 08:11 PM Thread Starter
Junior Member
 
Join Date: Apr 2013
Location: Kansas
Posts: 2
 
2007 PROWLER several issues HELP !!

2007 Prowler utility vehicle:

How does one remove the underhood storage box ?? The fan quit running and I would like to check the wiring, and whatever else. Are there diodes or relays firing the fan. The fuse is good.

I removed the hood, and I will reconfigure how it mounts with permanent bolts in the hinge and then clevis pin clips on the bottom of the bolts for quick removal. No more vise grips and socket. It would be easy to remove the hood if I didn't have a winch. If the hood had an indentation for the winch that would be great.

We found the oil filter tucked in behind the engine hiding from sight.

We found the oil drain plug by peaking through the skid plate.

I replaced the battery and had to remove a splash guard at rear tire and on and on. I hope it is in a more convenient place on future models....maybe it is.

Does the CD manual cover any of the above ?? Is there a printed manual ??

THANKS..............IT'S GREAT TO DRIVE
bradnree is offline  
Sponsored Links
Advertisement
 
Old 04-27-2013, 06:15 AM
Lifetime Member
 
mlh1962's Avatar
 
Join Date: Jul 2011
Location: Lexington, Missouri
Posts: 3,617
 
Garage
You can download a free repair manual using the link below, should help with most of your questions.
"K&T Parts House Lawn Mower Parts and Chain Saw & Trimmer Parts"

'07 Prowler 650 H1 XT, L.E.D. stop/turn signals, Summit Racing heater, AC winch, AC windshield, soft cab & doors, 6' Eagle Plow, oil gauge, Maxxis MT-762 truck tires, AC Fender Flares, E-Brake alarm, Yutrax UTV Jump Seat, Dynatek CDI
Missouri Mike
mlh1962 is offline  
Old 04-27-2013, 06:17 AM
Lifetime Member
 
mlh1962's Avatar
 
Join Date: Jul 2011
Location: Lexington, Missouri
Posts: 3,617
 
Garage
And Welcome to the site!

'07 Prowler 650 H1 XT, L.E.D. stop/turn signals, Summit Racing heater, AC winch, AC windshield, soft cab & doors, 6' Eagle Plow, oil gauge, Maxxis MT-762 truck tires, AC Fender Flares, E-Brake alarm, Yutrax UTV Jump Seat, Dynatek CDI
Missouri Mike
mlh1962 is offline  
 
Old 04-27-2013, 09:57 AM
Senior Member
 
Mavic19's Avatar
 
Join Date: Nov 2012
Location: Nampa, Idaho
Posts: 414
 
Ya, the Prowlers have some interesting design choices, but after you get used to them and compare it next to some other side by sides out there, you'll come to appreciate a lot of what AC engineers did. Download that service manual. I did, printed it out double sided and put it in a binder. It comes in really handy.

09 Prowler 700 XTX, Dynatek FS cdi and coil kit, Maxxis Bighorns, Warn 3500 lb winch, factory windshield/wiper and roof, Trail Armor doors, cage chopped 4", BEARD rear bench seat w/ 4 point harnesses, custom built extended cage. Rockford Fosgate RFX9400 marine stereo, Scosche 6.5' 3-way speakers in custom built overhead console and MB Quart NAU260 marine amplifier. Cobra CB. Sunpro volt, oil pressure and water temp gauges. Custom gauge plate built by RD. Peel 7 Seal lined doghouse.
Mavic19 is offline  
Old 04-27-2013, 02:13 PM
de3
Loyal Member
 
de3's Avatar
 
Join Date: Mar 2012
Location: parkersburg wva
Posts: 8,040
 
Quote:
Originally Posted by bradnree View Post
2007 Prowler utility vehicle:

How does one remove the underhood storage box ?? The fan quit running and I would like to check the wiring, and whatever else. Are there diodes or relays firing the fan. The fuse is good.

I removed the hood, and I will reconfigure how it mounts with permanent bolts in the hinge and then clevis pin clips on the bottom of the bolts for quick removal. No more vise grips and socket. It would be easy to remove the hood if I didn't have a winch. If the hood had an indentation for the winch that would be great.

We found the oil filter tucked in behind the engine hiding from sight.

We found the oil drain plug by peaking through the skid plate.

I replaced the battery and had to remove a splash guard at rear tire and on and on. I hope it is in a more convenient place on future models....maybe it is.

Does the CD manual cover any of the above ?? Is there a printed manual ??

THANKS..............IT'S GREAT TO DRIVE
Welcome aboard,great site there is a diode in the fan wiring harness it will have tape wrapped around it its up around the radiator,there has been some problems with the diode going bad.

2015 A/C Sport,With a few add ons..........
de3 is offline  
Old 04-28-2013, 08:59 AM
Loyal Member
 
GTroyer's Avatar
 
Join Date: Nov 2009
Location: Reno/Sparks ,Nv.
Posts: 3,287
 
OOOOPS ... read post and didn't say Howdy and a welcome to this site .... my bad !

name is Gary or hey you if ya forget

2009 Prowler XTZ , couple things added here and there
'83 CJ7 / SBC + whole lot added here and there
'01 Dodge / Cummins / Dually, a ton of stuff added here and there

INSTRUCTIONS FOR THE NEWBIES ...
1. Bring in a good load of firewood for the pit
2. start the morning coffee , strong but not burnt / boiled down , IMPORTANT start it early as many of us old farts get up early !!
3. sit a spell and swap some lies with the best of us
GTroyer is offline  
Old 04-28-2013, 09:49 AM
Rides all the time
 
Join Date: Jul 2011
Location: Middleton, ID
Posts: 1,489
 
To remove storage box, remove the screws securing it under the dash (removing the 4 dash screws in the doorway will help lift the dash and give you more access). Remove the two screws on the front of the storage box. Then there is a flap on the storage box that kinds of locks behind a metal support. Grab two long screwdrivers (or something else) and pry that flap forward until it clears the metal support while you lift up at the same time. Once that flap clears, the box will come right out.

Name: Shane

-2011 Polaris RZR-4 800 (SOLD)
-1999 Polaris Sportsman 500 ATV
-2006 AC Prowler 650XT (SOLD)-- updated bevel gears, updated oil pump driven gear, 4 wheel disc brakes, line lock E-brake, Papa Slap clutch, Xentec HID's, Dynatek CDI, Warn skid plates, Intellitronix gauges, 2010 intake/cvt duct work and dust shield, RZR seats, Bestop folding windshield, full cab kit, rear cage and rear seats (4 seater)
out west is offline  
Old 04-28-2013, 07:35 PM Thread Starter
Junior Member
 
Join Date: Apr 2013
Location: Kansas
Posts: 2
 
fan fixed
storeage box removed, and also removed windshield to accomplish this
oil and filter changed after removing skid plate
power washed it all
2100 hours
bradnree is offline  
Old 04-28-2013, 08:42 PM
Loyal Member
 
Joes5091's Avatar
 
Join Date: Apr 2009
Location: Waddell/Surprise. AZ
Posts: 2,681
 
Glad you got it done, Welcome to the forum.
Joes5091 is offline  
Old 04-29-2013, 02:39 AM
Lifetime Member
 
muddogefi's Avatar
 
Join Date: Jan 2011
Location: r.i.
Posts: 1,083
 
welcome to the site!!
muddogefi is offline  
Sponsored Links
Advertisement
 
 

Bookmarks

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Arctic Cat Prowler Forums: Prowler UTV Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Thread Tools



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome
 


1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73