Arctic Cat Prowler Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
157 Posts
Discussion Starter #1
Was installing the engine in my 07 650H1 xt. I had all the wiring hooked up when I went to install drive shaft I saw a spark between shaft and engine. Upon furthe examination I found no ground connection between the engine and the frame. This is not right as all electrical current would then have to travel through engine bearings to frame. I installed a ground wire between the two and ended this issue. Anyone else experianced this?:confused:
 
1 - 2 of 2 Posts
Top