Arctic Cat Prowler Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I bought this as a Project and wanted to sell once I was 100% Satisfied it was Mechanically sound. So much for that idea.
Did the usual put new in-line filter in after replacing the timing chain since it had slack. And set the voltage on the TPS to 0.40 with meter. Left it loose to adjust, after starting. Run great for bit then stopped getting fuel. So next replaced the fuel pump regulator and fuel pump. And replaced the Injector.
Now it sprays hard one time after turning ignition then does nothing. Have Ohm'd out all wires from ECM to Injector and Verified continuity using a 9v tester.
Still sprays once and does not spray again. Turn off key and do again same results.
Any freakin idea why it only sprays once and then quits ?
 
1 - 1 of 1 Posts
Top