Arctic Cat Prowler Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hey guys justin here from nh I got a 2009 xtx 700 and I'm having issues with the gauge cluster. Back light is on but no readings of anything else. Pulled cluster because it had moisture in it dried it out still doesn't work and it's causing the machine to go into a limp mode if you will. Won't go over 25 bounces off rev limiter. Any ideas? New cluster or is there a way to bypass it to get it out of limp mode
 

·
Administrator
Joined
·
7,221 Posts
Welcome to the site. Cluster would be hard to bypass. I'll look at a wiring diagram as I have the same machine. Clusters seem to be different from year to year. If you don't have a manual, you can download one at K&T lawn equipment. Clean all of the connections and try it again, who knows maybe luck will be on your side!
 

·
Administrator
Joined
·
7,221 Posts
Looked at the wiring, only wire I traced back that may limit RPM is the Blue & White from the override switch. Disconnect your battery and see if the cluster will clear. There is another post on here regarding EFI Codes that may, or may not help!
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
I've cleaned all the wires and dielectric greased every connection disconnected the battery and let it sit over night still nothing I ordered a new cluster should be in tomorrow so we will see
 

·
Administrator
Joined
·
7,221 Posts
Let us know how it worked out! Too bad someone doesn't repair the clusters!
 
1 - 5 of 5 Posts
Top