Arctic Cat Prowler Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
i was just wondering if anyone can tell me how to change the seal on the output shaft to the clutch . i have oil in the belt housing and it is slipping bad. thx
 

·
Registered
Joined
·
1,324 Posts
The easiest way to tell you and guarantee no bad info is to tell ya to go to the FAQ's and download the manual.

Decent size project to do, lots of steps.
Would be a pretty long-winded post
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
i changed the seals and brg. ran good for a couple of hours then belt started slipping again. took it apart oil in case again. any ideas?
 

·
Registered
Joined
·
1,324 Posts
Is the seal seated all the way?
How did the shaft look?.... grooved where seal rides?

I use rtv on the seal outer race of the new seal to seal it to the block.
 
1 - 5 of 5 Posts
Top