Arctic Cat Prowler Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
174 Posts
Discussion Starter · #3 ·
I can get a factory one for about $330 canadian so I guess cheaper than that I am happy. There's a company that makes shafts for rzrs called RHINO shafts, from superatv, and theirs are $200, but it looks like they only make them for the 700, does the 1000 use the same shafts, or am I just dreaming?
 

·
Registered
Joined
·
3,564 Posts
Wouldn't you upgrade the tie rods so it won't break and take the cv to the point of breaking the axle?Then you could just run stock axles.And only have to buy one.Because even if you buy the best axle on the planet it could still break if the tie rod breaks.



 

·
Registered
Joined
·
174 Posts
Discussion Starter · #9 ·
thanks for looking. our dollar right now is .94 to your 1, so were lookin' up. Just talked to my dealer, so they might warranty everything. Shes very slow, so by chance, does anyone know the part # for the upgraded tie-rods and tie-rod ends for the XTZ? Any help is appreciated.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top