Arctic Cat Prowler Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1 (Edited)
Reading the service manual it said you need use a puller to remove the internal clutch assembly but mine slid right off ..... is this cool? Check out the cam gear on the crank it's roached
 

Attachments

·
Registered
Joined
·
28 Posts
Discussion Starter #6
The oil pump looks OK and spins fine. My thought now is if the motor was low on oil you would have some type of oil light come on ,right. Is there a oil pressure sensor on the motor. If there is then you would think the motor would not run when the pressure is to low. I,m going to get a whole new motor now and hope that I don't screw up the installation .
 

·
Registered
Joined
·
583 Posts
The oil pump looks OK and spins fine. My thought now is if the motor was low on oil you would have some type of oil light come on ,right. Is there a oil pressure sensor on the motor. If there is then you would think the motor would not run when the pressure is to low. I,m going to get a whole new motor now and hope that I don't screw up the installation .
Thats a good question, do these motors have low pressure shutdown safety?
 
1 - 7 of 7 Posts
Top