Arctic Cat Prowler Forums banner

1 - 14 of 14 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1 (Edited)
The shaft to the rear gearbox is turning but the disk break is not??? just wondering if anyone has seen this.:(
Looking at the drive train break down it looks like the rear drive shaft is spinning in the shaft input. Has anyone seen this and if so what must be done to fix it??
 

·
Registered
Joined
·
1,324 Posts
turning inside input shaft???? Don't get the inside part of desc.

The drive line is bolted to a flange on the rear diff. Is that flange turning?
 

·
Registered
Joined
·
583 Posts
The shaft to the rear gearbox is turning but the disk break is not??? just wondering if anyone has seen this.:(
Looking at the drive train break down it looks like the rear drive shaft is spinning in the shaft input. Has anyone seen this and if so what must be done to fix it??
What model prowler? If you have the center mounted disk then it must be turning if driveshaft is.
 

·
Registered
Joined
·
22 Posts
Discussion Starter #10
What model prowler? If you have the center mounted disk then it must be turning if driveshaft is.
It is a 2008 XTX 700 H1
The disk is mounted to the shaft input (# 29 in the break down) and the drive shaft is turning but the shaft input and the disk is not. The splines are stripped out of the shaft input. :mad:
Anyone else had this happen if what could cause it?
 
1 - 14 of 14 Posts
Top