Arctic Cat Prowler Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
I'm wondering if anyone else has purchased and installed a Promark winch on their prowler.
I have a 2008 Prowler and I punched a 3500lb Promark Winch and mounting bracket from Promark and it doesn't seem to be lining up correctly. If I install the bracket per the instructions the power leads from the winch rest on the frame, which obviously is not correct. I was wondering if by chance any of you had the same setup and if you had pictures of how yours is installed.

Because I have less than 15 post I can't include a link on this post. So if you go to Photobucket and search for my username which is [email protected] you'll see all my "Prowler" Album.

Thanks for your help.
 

·
Registered
Joined
·
3 Posts
Mine isn't a Promark, mine is a Venom.. But I had a simliar problem on my '08 Prowler. If I were to mount it how the directions said, one of the power leads would be against the frame.

See this thread: prowlertalk.net/forums/arctic-cat-prowler-general-discussions/2507-mounting-winch-angle.html

I didn't use the Fairlead mount at all. I just used the model specific mount that came with the winch for extra strength and just ran the bolts through the front of the Prowler into the winch. I used longer bolts on the bottom where it went through the roller fairlead into the winch.

The winch manufacturer said it was OK for me to mount this winch at any angle. I'm not sure if they're all like that or not.
 

·
Registered
Joined
·
12 Posts
Discussion Starter #3
I got a hold of their customer service and it turns out I got the wrong winch. I'm returning it and selecting another.
They have a very helpful customer support.
 

·
Registered
Joined
·
656 Posts
Glad it worked out. Good customer service makes all the difference in the world.
 
1 - 5 of 5 Posts
Top