Arctic Cat Prowler Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
463 Posts
Discussion Starter #1
I just replaced tie rod nuts and figured I would check the alingment. What is everyone setting there toe at?
 

·
Premium Member
Joined
·
413 Posts
I believe it is supposed to be 1/4 inch outwards \---/
Correct! The Service Manual, Sec 8-9 says:


NOTE: All measurements and adjustments must

be made with the vehicle unloaded.


Mark the center-line of the front tires at the front and
rear of the tire; then using a tape measure, measure and
record the distance between the marks at the front and
rear. The front measurement should be 6-12 mm
(1/4-1/2 in.) greater than the rear measurement
(toe-out).
 

·
Registered
Joined
·
463 Posts
Discussion Starter #4
Ok thanks guys. That is what I thought I saw on here somewere.
 

·
Registered
Joined
·
2,681 Posts

·
Registered
Joined
·
463 Posts
Discussion Starter #7
Ok thanks sandchris
 
1 - 7 of 7 Posts
Top