Arctic Cat Prowler Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
199 Posts
Discussion Starter #1
So I cut in a water temp and oil pressure gauge.

But I don't know what is normal on a 10' XTZ.

Bueller?
 

·
Registered
Joined
·
421 Posts
so i cut in a water temp and oil pressure gauge.

But i don't know what is normal on a 10' xtz.

Bueller?
oil pressure spec in manual is 10-20 psi @2500rpm @ operating temp.thermostat spec is 164-170f so coolant temp should run 170-200 depending on your ambient temp.
 

·
Registered
Joined
·
199 Posts
Discussion Starter #4
What guage and sensor setup did you use for water temp I am looking for an inexpensive guage setup to use.
Pretty sure these are Autometers. I hope they are not inexpensive :D

oil pressure spec in manual is 10-20 psi @2500rpm @ operating temp.thermostat spec is 164-170f so coolant temp should run 170-200 depending on your ambient temp.
Cool thank you. I'm right in there. Oil pressure seemed low, my boat runs 90+psi, so almost everything else is low compared to :D
 

·
Registered
Joined
·
2,390 Posts
oil pressure spec in manual is 10-20 psi @2500rpm @ operating temp.thermostat spec is 164-170f so coolant temp should run 170-200 depending on your ambient temp.
I just got a new thermostat for my XTZ 1000 and when I switched it out it had a factory 160 degree in it but the new part is a 190 degree thermostat. Wonder why the change?
 

·
Registered
Joined
·
277 Posts
My '09 runs a consistent 180-185 degrees. Can't say about the oil pressure.
 
1 - 6 of 6 Posts
Top