Arctic Cat Prowler Forums banner

1 - 2 of 2 Posts

·
Administrator
Joined
·
7,281 Posts
Discussion Starter #1
I've been wiring my gauges, and changing the grounds. About 3 years ago when I was wiring my car, I ran across a Butane Soldering Iron at Radio Shack. This tool is great on # 10 wire and smaller. I picked up the solder at the Shack also, very fine solder with a flux core. I also installed a lite for the switch panel (motorcycle license plate lite). The first picture is the light, 2nd is the soldering iron, the remainder are the additional ground points. The bolt through the floorboard is a grounder stud for any future needs. RD
 

Attachments

·
Premium Member
Joined
·
8,040 Posts
looks good RD,your right into buddy.I also went to the frame on the ground on my volt gauge also.
 
1 - 2 of 2 Posts
Top